• Welcome to the ElgrandOC forum.

    You will find that the majority of the forum is locked, but do not worry. You can unlock more content by registering to the forum completely free. Sign up is automatic, does not require email confirmation and is instant. Feel free to browse through the sections to see what topics have been covered before you register.
    You can register for an account by CLICKING HERE

    Once you have registered, you will unlock more of the forum content. You will not unlock all of the content until you have reached 10 posts. This is to give you an opportunity to chat to existing members and help to integrate you into the forum community.
    We are a friendly and helpful community and there is a wealth of infomation contained within the forum. Please feel free to register, introduce yourself and get to know your fellow members.

    Feel free to look at the Frequently Asked Questions section, the Meets/Events section and the Competition Section without having to register.
    We look forward to getting to know you and help you with any questions or problemd you have with your Elgrand.

Show us your knob

I went from standard to an 8 ball but at 60mm dia - it was too small.



I then tried a crown green bowling Jack at 75mm dia which was good and had nice heft, the colour also matched the dash illumination.💡





Finally I bought this Dandelion, set in resin - again at 75mm dia, it signifies how my van is good for the environment.🤗





👍
 
I'd quite like a new knob as the one I have is quite small. What should I be searching for when looking? Do they just unscrew? And buying recommendations? Thanks.
 
Added this as I liked the perforated leather matching the dash and steering wheel. Was not sure, so it came off again……😆
 

Attachments

  • 5B636C47-F407-4CC1-B5D3-0317F254E2C2.jpeg
    5B636C47-F407-4CC1-B5D3-0317F254E2C2.jpeg
    412.5 KB · Views: 29
Due to my abnormally large hands, I often knock the blinking thing into neutral with the standard one, so might look at the 8 ball, or one like my hand shift Harley of a similar size. What's the thread size on the shaft?
 
I decided to buy a nifty Momo chrome knob but after 1 winter using it decided wasn't keen on having my hand frozen stuck to it and I'm way too old for Mittens so decided to refurbish the original using LCD products. Next job steering wheel.20220917_133718.jpg
 
Getting a bit "bored with the sword" after 12 months, any suggestions for change?
new gearknob.jpg
 
Last edited:
I'm wanting to 3D print a shift knob for my E51 S2. Are these standard direction threads, and what's the size/pitch?
 
You must log in or register to reply here.
Back
Top